Parade Flag Holder

$159.95

Display up to three full size flags easily, prominently, safely and with a very custom show look.

Install our trailer hitch or model specific receiver bracket, (sold separately) to your trailer hitch or saddlebag rails. The flag holder bar with flag socket (one included with #PF1000 parade flag holder) can then be installed, attached or detached from the bracket(s) in seconds by removing two safety pins.

Also the trailer hitch mounted bracket will not interfere with your trailer’s coupler and does not need to be removed when towing.

One or two more additional flag socket(s) can be added (PF920, sold separately) to accommodate up to three flags. The socket(s) accommodate up to 1 1/4” poles, and are machined at a 15o angle to their bases. They can be rotated to display your flags, as desired. The holder is machined from aircraft quality aluminum, and the socket from steel, then both are polished to a flawless finish and triple chrome plated.

NOTE: One of the following model specific mounting and hardware sets listed below must be ordered separately to make a complete flag holder assembly.

HWK010 - for any motorcycle with an existing trailer hitch.

HWK015 - For all (2008 and earlier) Harley-Davidson FL & FLH models

HWK020 - For all (2009 & newer) Harley-Davidson FL & FLH models.

 

NOTE: The use of the following items, Part# GL18010, Part# GL18008, Part# QD1000, and Part# PF1000 on any un-sprung trailer hitch (example: Voyager Trike Conversion Hitches, any hitch on a Can Am Spyder, or any other un-sprung hitch) will void the warranty. These products were not designed to handle the excessive vibration and impacts from un-sprung trailer hitches, and the products may be damaged when used on those applications.


Add to Cart:

  • Model: PF1000
  • Manufactured by: Rivco


This product was added to our catalog on Tuesday 16 July, 2013.

Your IP Address is: 54.198.210.67
Copyright © 2017 AutoandMotorcycle Chromenstuff. Powered by Zen Cart
The Range 1